How does the central dust removal system work? from khedmehcom's blog

The widespread use of central dust removal system can be said to be the continuous improvement of the bag, which makes the bag dust collector have a high dust removal rate. The bag is also known as the heart of the bag dust collector. For the maintenance of the bag, it can be said that the proportion is larger, so the bag is the key to directly affect the rate of the bag dust collector. The bag damage is caused by nothing more than a few reasons: high temperature burn, corrosion, mechanical damage and installation is not good and the quality of the bag these reasons. For dust particles smaller than 1μm, 0.2-0.4μm dust particles have the lowest dust removal rate. Both for clean filter material or dust filter material have a similar situation. This is because for the dust particles in this size range, the effects of several kinds of trapping dust are in the low value region. The electrostatic charge carried by dust particles also affects the dust removal rate. By using this characteristic, dust can be charged in advance, so that a high dust removal rate can be obtained for fine dust.

How does the central dust removal system work? The following is a detailed introduction for you:

1. No matter how high or low the pressure of the pulse injection air source is, it is for the purpose of achieving all the cleaning, and the cleaning energy is the same.

Two, the jet cleaning mechanism is divided into a combination of no drainage nozzle without Wenn tube, no drainage nozzle without Wenn tube and drainage nozzle with Wenn tube.

Three, central dust removal system of bag dust removal system has online dust removal and offline dust removal. By adjusting the parameters of the dust collector, the same effect can be achieved on line and off line.

Four, the injection pressure is low pressure injection, the pressure is lower than 0.4MPA, high pressure injection, the pressure is higher than 0.4MPA. High pressure air source has large kinetic energy and less gas consumption, while low pressure air source has small kinetic energy and more gas consumption.

Five, cleaning device blowing pipe blowing.

central dust removal system external filter bag dust removal system, its filter bag adopts flat bag, the cross section shape of dust bag into trapezoid or wedge. Compared with circular filter bag, it has small footprint and compact structure under the condition that the filter load per unit area of filter cloth is the same. The operating pressure of the central dust removal system is determined according to the static pressure value of the device and the fan before and after the dust collector and its installation position, which is also the design of the central dust removal system.

In the process of using the central dust removal system, we need to cooperate with corresponding electric heaters or far-infrared electric heaters, which will be more convenient to use and conducive to improving the working speed. If the temperature rises and then decreases, there may be condensation, and then naturally there will be a large number of scaling, which needs to be cleaned regularly. Therefore, when we use the dust collector, we need to have a proper heating mode, so as to ensure the operation of the equipment, but also to prevent condensation.

central dust removal system https://www.kaisenfilter.com/Central-Dust-Collector